| Description |
|
|
This Accumulator Tank is intended for installation in any pumped water system controlled by a pressure switch. For example, PAR-MATE 2.5 or any Jabsco pressure pumps as found in boats, RV's, motor caravans, coaches and similar applications. The Accumulator Tank smooths water flow and reduces on/off cycling of the pump by lessening the variation in pressure and flow between the pump and the outlets in the system. The even flow of water gives better control of hot water temperature especially noticeable with instantaneous gas water heaters and with showers. The reduced on/off cycling reduces noise from the pump motor, and from shock pressures (pipe hammer). It alsoreduces battery drain, and gives longer pump life. |
Aqua FiltaTM is an activated carbon water filter that removes chlorine, unpleasent smells, tastes and colors from marine water systems and uses specially silver-impregnated carbon to inhibit bacterial growth in the filter bed. Aqua FiltaTM absorbs dissolved impurities but retains beneficial mineral salts, thus freshening and cleansing water to make it natural tasting, sweet smelling and crystal clear. |
These compact pre filters prevent particles jamming valves and causing pump breakdowns - we’ve given them a screw off, transparent housing for easy inspection and quick, in place cleaning. Our new Universal model makes it easier than ever to install your pump by fitting directly into diaphragm pump inlet port as well as benefiting from swivelled angled inlet port on a rotating body so inlet hose can approach from any direction! |
This accumulator tank is intended for installation in any pumped water system controlled by a pressure switch, and may also be used with air-driven pumps. The tank can serve as a storage vessel as well as a pulsation dampener for pressurized fluid. The accumulator tank smoothes water flow and reduces on/off switch cycling of the pump by lessening the variation in pressure and flow between the pump and the system discharge points.The even flow of water gives better control of hot water temperature with systems using instant water heaters. |
IMPROVES MOST AUTOMATIC WATER SYSTEMS
This accumulator tank is intended for installation in any
pumped water system controlled by a pressure switch, and
may also be used with air-driven pumps. The tank can serve as
storage vessel as well as a pulsation dampener for pressurized
fluid. The accumulator tank smoothes water flow and reduces
on/off switch cycling of the pump by lessening the variation in
pressure and flow between the pump and the system
discharge points. The even flow of water gives better control of
hot water temperature with systems using instant water
heaters.
PRE-CHARGE PRESSURE ADJUSTMENT
The accumulator tank is pre-charged at 10 psi (0.7 bar). If your
pump electric pump cut-in pressure is significantly different
you may adjust the tank pressure to better suit your particular
installation.
To increase air pressure in tank, shut pump off, open a faucet
to relieve system pressure and adjust precharge pressure
using ordinary tire gauge and tire pump at valve in end of tank.
Pressure should be checked from tome to time. To check tank
pressure: turn off power to water pump, open a faucet to
relieve pressure. Check tank pressure, adjust if necessary.
Close faucet and turn on power to pump. For best results, do
not pressurize tank above 20 psi (1.4 bar). |
Water pressures from 46-125 psi (3-10 bar)will be regulated down to 45 psi (3 bar).Lower pressures will pass through unregulated.Variance is ± 5 psi (0.3 bar). |
Variable Speed Drive (VSD) converts everyday pumps into sensor-controlled pumps that automatically adjust in real time to changes in pressure. As less flow is required, the pump motor slows down to provide a smooth and pulsation-free performance. |
